Instructions
The instructions below are a guide of how to properly apply and remove your wraps and decals. Be sure to follow the instructions as they are shown, in the order they are listed. You can also check out our full length tutorial in the video below:
Full length tutorial shown here:
How to APPLY wraps and decals
1. Start by removing the laces of your cleat and making sure the cleat itself is clean and dry
2. Place your wrap on your cleat in the desired location and firmly press down the hatched area in red. Once the edge of the wrap grips your cleat, peel back the transition paper slowly, and using your finger gently push the wrap down as you continue to peel.
3. After the wrap is secured to your cleat, use your fingernail to trace the contours of your cleat so that it has a clean look
4. Now that the shape of your cleat is outlined, use your guitar pick to cut the excess wrap. Follow along the same contours you used your fingernail for
5. Pull away the excess wrap material along the contours of your cleat
6. Place your next wrap down, overlapping the one you already completed. Follow the same instructions as listed
7. Poke holes inward where your laces will be threaded. Pulling the laces outward may result in displacing the wrap
How to REMOVE wraps and decals
1. Start by removing the laces of your cleat
2. Thoroughly heat your wrap/decal with a blow dryer
3. Roll your thumb along the wrap to begin to remove it
4. Continue to heat the wrap as you slowly pull upward on the rolled section. The wrap will begin to come undone
2.
3.
4.
5.
6.
7.
